Spiral chute iron removal

Spiral chute iron removal 1. Describing the beneficiation chute belonging to the inclined flow separation step. Mineral mortar is provided to a partially inclined chute or inclined surface. Under the push of water flow, the mineral particle group becomes loose and layered. The upper layer is so light that the mineral quickly flows out of the groove, while the lower part of the heavy mineral material stagnates inside the groove or flows out at a low speed from the lower end. After obtaining it, concentrate and tailings are obtained. Spiral concentrator is a mining and beneficiation machine, especially ideal for sand mining on beaches, river beds, beaches, and streams. The equipment is reasonably structured, easy to install, occupies a small area, has simple operation, stable beneficiation, clear mineral separation, large production capacity, high efficiency, high enrichment ratio, high recovery rate, and stable operation. It has the advantages of light weight, moisture prevention, rust prevention, strong corrosion resistance, and strong adaptability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 The technical principle is that the mineral mortar is slowly fed onto the rotating groove surface through a feeding groove installed at the head of the spiral groove for sorting. The tail of the spiral groove is equipped with a valve type product selection groove, which divides the selection equipment into three categories according to grade along the radial direction. By adjusting the orientation of the valve block to change the cutting width of each product, the equipment gathering hopper enables the multi-directional mineral flow to be differentiated and converged. The transverse surface of the fiberglass chute and the slope change of the curve are particularly suitable for the selection of fine particle materials. Spiral Chute Iron Removal III. Advantages: 1. Stable, easy to operate, and with a large density range. 2. Large material processing output, high enrichment ratio, and high recycling probability. 3. Small footprint, low water consumption, simple construction, and no need for power. 4. Easy installation, easy operation, minimal investment, and fast returns. The spiral chute is composed of six parts, including a feeding homogenizer, a feeding groove, a rotating groove, a product selection groove, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The spiral groove formed by the connection of spiral plates is a key component. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together by bolts. The rotating groove has a pre designed durable and wear-resistant layer on the selected surface. She has the advantages of lightweight, solid, and durable use of consumer goods. The spiral groove is equipped with a multi tube feeding homogenizer above it to screen the ore, which is also easy to operate. The concentrator is not limited to being placed on a cross (or tripod) on a support table. The evenly distributed mineral mortar is slowly fed onto the surface of the spiral groove through the feeding chute installed at the head of the rotating groove, and sorting is carried out. The bottom of the rotating groove is installed in a valve block type new equipment cutting groove, allowing other new products to be selected and classified into three (or four) categories according to grade along the radial direction. Change the acquisition width of each new product by adjusting the position of the valve block. The new equipment gathering bucket is a concentric circular tube that converges and leads out the intercepted multi-directional mineral flow. The transverse section of the spiral chute has a slope change, which is particularly suitable for the sorting of fine-grained materials. 5、 Use This machine is suitable for sorting iron ore, ferrotitanium ore, chromite ore, pyrite ore, zircon ore, Rutile, monazite, phosphate ore, tungsten ore, tin, tantalum niobium, niobium with a particle size of 0.3-0.02mm and other non-ferrous metal ores, rare metals and non-metallic ore bodies with different density and specific gravity. Spiral chute iron removal Spiral chute iron removal