Baryte spiral chute beneficiation

Baryte spiral chute beneficiation

Baryte spiral chute beneficiation I, product introduction This is a gravity beneficiation equipment that uses the inertial centrifugal force appearing in the spiral rotation movement of pulp to separate light and heavy mineral materials. 2、 The principle of operation is that the spiral concentrator does not limit the placement of the mineral screening device on the cross (or tripod) of the support table. The average mineral mortar is slowly fed onto the spiral groove surface through a feeding groove installed on the rotating groove head, and the selection is carried out. The bottom is equipped with a valve block type equipment cutting groove, allowing the sorted products to be divided into three (or four) types according to grade along the radial direction. Change the selection width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that aggregates and leads out the obtained multi head ore flow. The transverse section of the fiberglass chute and the change in slope of the curve are particularly suitable for the selection of small particle materials. Baryte spiral chute beneficiation 3. Characteristics 1. The beneficiation process is stable and easy to control 2. The allowable range of feed concentration is relatively large 3. The enrichment ratio is high and the recovery probability is high 4. The land area occupied is small and the water consumption is low 5. The structure is simple and no power is needed 6. The processing output is large 7. The installation is simple and easy to understand, and the operation is simple 8. The input is small and the results are fast. Baryte spiral chute beneficiation 4 The structure of the fiberglass spiral chute consists of six parts: a feeding homogenizer, a feeding chute, a spiral groove, a product acquisition groove, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The rotating groove formed by connecting rotating discs is the main component. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and is connected together through screws. The sorting surface of the spiral groove has a pre designed durable wear-resistant layer. She has the advantages of being lightweight, sturdy, and durable in using consumables. There is a multi tube feeding homogenizer above the rotating groove to screen minerals evenly, which is not cumbersome to operate. The screening machine does not need to be restricted from being placed on the cross (or tripod) on the support table. The uniform slurry is slowly fed to the surface of the spiral groove through the feeding groove on the rotating groove head, and sorting is carried out. The tail of the rotating groove is installed in a valve type new equipment selection groove, allowing the sorted new products to be divided into three (or four) types of new products according to grade along the radial direction. Change the width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that separates and merges the intercepted multi-directional mineral flows. The cross section of the spiral chute and the slope change of the curve are very applicable to the selection of fine materials. 5、 Scope of application: FRP spiral chute is suitable for separating fine particles of iron, ferrotitanium, ferrochromium, ferrosulfide, tin, tantalum and niobium, gold, coal, monazite, Rutile, zircon, rare earth and other metal and non-metallic mineral materials with complete Density contrast. Baryte spiral chute beneficiation Baryte spiral chute beneficiation

Baryte spiral chute beneficiation