Spiral chutes affect grade

Spiral chutes affect grade 1. Introduction: Chute beneficiation includes the inclined surface flow separation process. The slurry is fed to a partially inclined chute or inclined surface, and with the assistance of water flow, the mineral particle group becomes loose and layered. The light minerals on the upper part are quickly discharged to the outside of the chute, while the heavier minerals on the lower part stagnate in the inner chute or slowly discharge from the lower part. After obtaining each, concentrate and tailings can be obtained. Glass fiber reinforced plastic chutes are equipment for mining and beneficiation, making them ideal for sand mining by the sea, riverbanks, sandbanks, and streams. The product has the characteristics of correct structure, simple installation, small footprint, easy operation, stable beneficiation, clear screening of minerals, high processing yield, high efficiency, high beneficiation enrichment ratio, high recycling rate, and stable operation. It has the advantages of light weight, moisture-proof, rust prevention, corrosion prevention, strong adaptability to the fluctuation of feed volume and density, Granularity, and grade. 2、 The mortar with the same working principle is slowly fed onto the surface of the spiral groove through the feeding chute installed at the end of the rotating groove head, and selected for operation. The tail of the rotating groove is equipped with a valve block type product cutting groove, which divides the sorting equipment into three categories according to grade along the radial direction. By adjusting the position of the valve block to change the acquisition width of each product, the equipment gathering hopper enables the selected multi head ore flow to converge and export separately. The cross-section of the spiral chute and the slope of the curve change greatly, which is applied to the selection of fine ore materials. spiral chute affects grade 3. Features This machine is suitable for separating iron ore, ilmenite ore, chromite ore, pyrite ore, zircon sand, Rutile ore, monazite ore, phosphorus, tungsten sand, sand tin, tantalum niobium, tantalum niobium and other nonferrous metal ore bodies with density specific gravity difference from 0.3-0.02mm small materials. This machine has advantages such as stable sorting process, easy control, wide range of ore concentration tolerance, high enrichment, high recovery probability, small land occupation, low water consumption, simple structure, no need for power, large production capacity, simple installation, simple operation, small investment, and quick effectiveness. The influence grade of spiral chute is . 4. The chute can be divided into three categories according to the particle size of the processed ore material: (1) coarse chute, the maximum Granularity of the feed is more than 2-3 mm, and the maximum can reach 100-200 mm. (2) Sand ore chute, processing 2-3mm Granularity ores. (3) The slurry spiral chute, with a feeding particle size of less than 0.074mm. 5、 The application scope of fiberglass chute is used for processing 0.6-0.03 millimeters and this vein or placer ore, but it is unfavorable for sorting when the mud content is high. Currently, it has been widely used for processing iron ore, tungsten, tin ore, tantalum niobium ore, coastal and riverine minerals, and gold ore. Spiral chute affects grade Spiral chute affects grade