Working diagram of multiple spiral chutes

Working diagram of multiple spiral chutes

Multiple sets of spiral chutes work diagram 1 describes gravity beneficiation, which is widely used in the beneficiation of metallic and non-metallic ores due to its low pollution and cost. The spiral concentrator is one of the gravity separation machines, with a structural feature that the cross-section presents a cubic parabolic shape, suitable for processing finer particle sizes of -0.2mm. In the sorting process, there is no need to add flushing water, and the fine, medium, and tailings are segmented at the tail end of the tank. 2、 Working principle: The fiberglass chute separator does not need to be placed on a cross (or tripod) on a support table. The same mineral mortar is slowly fed onto the rotating groove surface through the feeding chute installed at the head end of the spiral groove, and sorting is carried out. The bottom is equipped with a valve block type product cutting groove, allowing the selected equipment to be divided into three types (or four types) according to grade along the radial direction. Change the selection width of each device by adjusting the orientation of the valve block. The product gathering bucket is a concentric circular tube that converges and induces the obtained variable mineral flows. The transverse section of the fiberglass spiral chute and the change in slope of the curve are extremely suitable for the selection of fine particle materials. Multi group spiral chute working diagram 3. Characteristics This product is suitable for sorting 0.3-0.02mm fine materials to get iron ore, ferrotitanium ore, chromite, pyrite ore, zircon sand, Rutile, monazite, phengite, tungsten sand, sand tin, tantalum, tantalum niobium and other non-ferrous metal ores, rare metals and non-metallic ore bodies with different density ratios. This equipment also has stable and easy to operate selection processes, a wide range of allowable changes in feed density, high enrichment ratio, high recycling rate, small land occupation, low water consumption, simple structure, no need for power, strong processing ability, easy installation, easy operation, low investment, and quick effectiveness. Working drawing of multiple groups of spiral chutes IV. According to the particle size of processed ore, the chutes can be divided into three types: (1) coarse spiral chutes. The maximum Granularity of ore feeding is more than 2-3 mm, and the maximum can reach 100-200 mm. (2) The sand ore chute is used to handle 2-3MM particle grade ore materials. (3) Slurry chute, feeding particle size less than 0.074 millimeters. 5、 The use of a range spiral concentrator is suitable for processing 0.6-0.03mm or vein ore and minerals, but it is unfavorable for separation when the mud content is high. Nowadays, it is widely used for processing iron ore, tungsten, tin, tantalum niobium ore, bay or riverbank ore sand, and gold ore. Multi group spiral chute working diagram Multi group spiral chute working diagram

Working diagram of multiple spiral chutes