What is the recovery rate of the spiral chute used for mineral processing

What is the recovery rate of the spiral chute used for mineral processing

What is the recovery rate of the spiral chute used for mineral processing? 1. Introduction to the titanium iron spiral chute gravity separation experiment. Gravity separation is widely used in the beneficiation of metallic and non-metallic minerals due to its low environmental pollution and low cost. The spiral beneficiation machine is one of the gravity beneficiation machines, with a cross-sectional shape of cubic parabola, suitable for processing finer particle sizes of -0.2mm. During the sorting process, do not add flushing water, and cut off the fine, medium, and tailings in sections at the bottom of the tank. 2、 By using a method, the spiral chute is erected and aligned with the vertical line. An iron frame or wood is used to position it in a suitable position. The sand and ore are pumped by a slurry pump to the two feeding ports above the spiral, where water is added and the density of the mineral slurry is adjusted. The slurry naturally swirls from high to low, generating an inertial centrifugal force in the swirling slope flow velocity. The difference is based on the specific gravity, particle size, and state of the mineral sand, By utilizing the gravity and centrifugal force of the swirling flow, the sand and ore are separated. The selected ore enters the concentrate hopper and is piped out. The tailings are discharged into the tailings hopper and moved to the sand tank through a pipeline, and then discharged by a mortar pump, completing the entire beneficiation process. What is the recovery rate of the spiral chute used for ore dressing at ? 3. Advantages and characteristics: 1. Ultra high efficiency, high recovery and utilization rate, and precise mineral sorting; 2. Do not use power; 3. Lightweight, rust resistant, wear-resistant, and not easily corroded. 4. Low operating costs and long application life; Strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade; The friction caused by the surface of 6 diamond sand makes the beneficiation effect better than other plastic surfaces. What is the recovery rate of the spiral chute used for mineral processing, . 4、 The structural composition of the fiberglass chute is composed of six parts, including a feeding homogenizer, a feeding chute, a spiral groove, a product acquisition groove, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The rotating groove connected by spiral blades is the main component. The rotating plate is made of fiberglass (fiber reinforced coal gangue) and connected together through screws. The selected surface of the spiral groove has a pre made durable wear-resistant layer. It also has the advantages of lightweight, sturdy, and long-lasting consumables. The rotating groove is equipped with a multi tube feeding homogenizer for ore separation, which is simple and convenient to control. The mineral screening device does not need to be placed on a cross (or tripod) on a support table. The evenly distributed slurry is slowly fed to the rotating groove surface through the feeding groove installed at the end of the spiral groove head, and sorting is carried out. The tail end of the spiral groove is equipped with a valve type new product selection groove, which allows other new products to be divided into three types (or four types) of new equipment along the radial direction according to grade. Change the selection width of each new product by adjusting the orientation of the valve block. The new product gathering bucket is a concentric circular tube that densely exports the intercepted variable mineral flows. The transverse surface of the fiberglass spiral chute has different slopes, which is very suitable for the separation of fine particle materials. 5、 Applicable. This machine is suitable for sorting iron, ferrotitanium, ferrochrome, ferrosulfide, zircon, Rutile, monazite, phosphate ore, tungsten ore, tin placer, tantalum niobium ore, tantalum niobium ore and other non-ferrous metals, rare mineral metals and non-metallic ore bodies with gravity difference. What is the recovery rate of the spiral chute used for mineral processing? @ @ What is the recovery rate of the spiral chute used for mineral processing

What is the recovery rate of the spiral chute used for mineral processing