How to process tungsten ore with water flushing

How to process tungsten ore with water flushing

Tungsten ore is a common metal mineral widely used in aviation, aerospace, military, electronics and other fields, and plays an important role in modern industry. In the beneficiation process of tungsten ore, water flushing is a common method. So, how can tungsten ore be processed by flushing with water? This article will provide a detailed introduction to mineral processing principles, operating steps, precautions, and other aspects.

1、 Mineral processing principle

Water washing beneficiation is a method of separating ore using the force of water flow. In the process of washing tungsten ore with water, the ore is first broken into particles of a certain size, and then mixed with water to separate the ore through the force of water flow. Due to the high density of tungsten ore, it will settle to the bottom under the action of water flow, while light impurities will be washed away, thus achieving the purpose of mineral processing.

2、 Operating Steps

1. Preparation work

Before washing and beneficiation of tungsten ore with water, some preparatory work needs to be done. Firstly, the ore needs to be crushed into particles of a certain size. Secondly, it is necessary to prepare water sources and flushing equipment to ensure stable water flow and pressure. Finally, it is necessary to inspect the beneficiation equipment to ensure its normal operation.

2. Soaking

Put the crushed ore into the beneficiation tank, add an appropriate amount of water, and let it soak for a period of time. The soaking time is generally 10-20 minutes, which allows the ore to be fully mixed with water, laying the foundation for subsequent separation.

3. Flushing

After soaking, start rinsing. Turn on the flushing equipment and let the water flow impact the ore to separate it. During the flushing process, attention should be paid to the control of water flow and pressure, as well as the timing and frequency of flushing. Generally speaking, the flushing time should not be too long to avoid wasting resources, and it should also not be too short to avoid affecting the separation effect.

4. Separation

During the flushing process, tungsten ore will settle to the bottom, while light impurities will be washed away. After the ore is separated, it is separated using a sieve. The separated tungsten ore can be further processed and purified.

3、 Precautions

1. Control water flow and pressure

During the process of washing tungsten ore with water, it is necessary to control the water flow and pressure. A small water flow rate will affect the separation effect, while a large water flow rate will waste resources. High water pressure can cause damage to the equipment, while low water pressure can affect the separation effect. Therefore, when conducting mineral processing operations, it is necessary to control according to the actual situation.

2. Pay attention to safety

During the process of washing tungsten ore with water, attention should be paid to safety. Wear protective equipment to avoid accidents. At the same time, when using mineral processing equipment, attention should be paid to the operating status of the equipment to avoid equipment malfunctions.

3. Reasonable utilization of resources

During the process of washing tungsten ore with water, it is necessary to make reasonable use of resources. To control water flow and pressure well and avoid wasting water resources. At the same time, it is necessary to fully utilize the ore and reduce its waste.

IV. Conclusion

Washing tungsten ore with water is a common beneficiation method, which uses the force of water flow to separate the ore. When conducting mineral processing operations, it is necessary to control the water flow and pressure, pay attention to safety, and make reasonable use of resources. Through the above steps, effective separation of tungsten ore can be achieved, laying the foundation for subsequent processing and purification.

How to process tungsten ore with water flushing